Dear Nikki :

You need to move the cross-sections grids using our commands, not manually moving them.

To move the cross-section grids closer to the topo map, select Modules | Configure | Cross-Section Grids (or Input | Cross-Sections | Configure Cross-Section Grids). Then, from the displayed Configure Cross-Section Grids dialog box, choose <Pick> next to the Layout Point entry. You can then pick a point near to your topo map, and RMS / RiverCAD will move the grids to that new location.

Note that if you manually moved the cross-section grids, you may need to delete them (using our command, Input | Cross-Sections | Delete Cross-Section Grid) and recut your cross-section cut.

If you have any additional questions or need any further information, please contact me again.

Sincerely,

Chris E. Maeder, M.S.
Senior Technical Engineer
chris.maeder@bossintl.com