Thanks Ron,

I've actually been able to successfully view the velocity distribution
in the cross- section plot. What I'm looking for is tabular text output
from the report generator (File -> Generate Report ...). The end result
that I need is the peak discharge at a range of cross-sections based on
the flow distribution calculations performed by HEC- RAS. I realize
that you get tabular output with the cross-section table viewer, but
with more than a few cross-sections, this becomes a very tedious
process. Therefore, what I would like is a text file that reports the
velocity distribution at each cross- section. With this, I can write an
algorithm to extract the peak velocity from each cross-section that will
run in a few seconds. Any more suggestions?

Thanks!
Jeremy