Hello Ibrahim;

Change your SW and MM lines as below:
SW 1 0 0
MM 4 1 2 3 4

Enter Zeros for the STHETA and SPHI at the end of each C1 line.

You would then get the following error messages which you may correct as
you wish:

====> ERROR !!! JUNCTION 1025 REQUESTED FOR PRINTOUT IS NOT
CONTAINED IN JUNCTION DATA.


************************************************
* LINE-INPUT HYDROGRAPHS (DATA GROUPS K1-K3) *
*
*
* Expect 10 junction IDs on each K2 line. *
************************************************

NJSW INPUT LOCATIONS FROM K2 LINES:
5240 5230 5200 5090 2150 2150
2150
2100
2040 1150

*** ERROR! INPUT LOCATION 2150 IS DUPLICATED LATER IN K2 LIST.
ALLOW LOCATION TO BE USED ONLY ONCE. PROGRAM WILL STOP BELOW.


Good Luck!

Mostafa Bozorg-Zadeh (ICE)
bozorg@KOSAR.NET