|
Initial Values
Greetings,
I was having problems with initial values in my Unsteady Flow simulation, so I decided to do what it says in the manual when we're having stability problems at the very beginning of a run. I run the model with all inflow hydrographs set to a constant flow, and set the downstream boundaries to a high tailwater condition and decrease the tailwater down to a normal stage over time. Once the tailwater is decreased to a reasonable value, those conditions were written out to a DSS file, and then used as the starting conditions on the unsteady flow run. But when I run my model the message "The Hotstart file is not from Version 3.1.3 May 2005" appears in the Computation Messages Box, like in the attached picture.
I would like to know how I can solve the problem, and so, in witch way I can use a Restart File from a previous run in my current model calculations.
Thanks,
Mónica Piedade,
Master Degree Student in Hydraulic, Water Resources and Environment
Faculty of Science and Technology
University of Coimbra
Portugal
|