[ngarland]

I attempted to import the files but was unable to get the cross-sections to display properly on the topo map. They appeared only as lines. Maybe if I explain my process then it might be possible to determine where I went wrong of if what i am doing is possible.

I build a contour, and cross-section file in HEC-GeoRAS. Then export this file to HEC-RAS, then run an analysis. I then attempt to import the HEC-RAS project into RiverCAD. This builds the cross-sections vertical profiles, however there is no cross-section data that is applied to the top map, or the lines that exsist there. Is it possible to build just the lines on my topo map from HEC-RAS data, or do I have to rebuild them manually by linking them with the link command?