Data transfer facility

[Fredrik Persson]

Dear support!

I got a error message in all of my cross-sections when I generate data to transfer file, "Missing cross-section geometri data entries encountered at cross-section ... this could be cause by a blank entry" It´s perhaps really simple but I have only worked with the program for a week, so can you hopefully tell me the possible resonfor the error?

[Chris Maeder]

Dear Fredrik :

Note that you must define the cross section geometry with the same number of top widths at each cross section or DAMBRK will report this as an error. So, if you start with 5 top widths, then you need to maintain that number of top widths throughout the modeling process.

Also, you might have left some top width entries blank for storage or floodplain data at some of the cross sections where this data was defined completely at other cross sections. You can enter a value of 0.0 to get the warning message to disappear.

Sincerely,

Chris E. Maeder, M.S., P.E.
Senior Technical Engineer
chris.maeder@bossintl.com

[kkarakaya]

Hello,

I have just registered to this forum and I would like to learn if we can post our messages also about FLDWAV. I am doing my master science degree and I have to finish my study unfortunately only in 1 month. Please let me know if you can help me regarding my problems in FLDWAV.
Regards