Dear Justin :
Please see my comments below.
If you have any additional questions or need any further information, please contact me again.
Sincerely,
Chris E. Maeder, M.S.
Senior Technical Engineer
chris.maeder@bossintl.com
> 1. I have a error free model running with a piping failure. How would I set up the model to run with no failure but a PMF flood flow?
To prevent the dam from failing, set the Water Surface Elevation at Time of Failure to a very high value.
> 2. Also, I have an error free model running with an overtopping failure. One point I would like you to clarify more clearly in the Dam Overtopping Coefficient.
This is the coefficient that is used to compute the amount of dam overtopping flow. It is the weir flow coefficient times the dam length. It is described in detail in the on-line help.
> 3. In the manual it states that I can output graphic fills in DXF form. How?
It is the same as printing a graphical output file, except that you choose a DXF print driver and mode, and then write it to a file.
> 4. Would it be possible to sent me a new license disk with the correct spelling of CONSULTORES PICHI PICUN LEUFU UTE
Included in this email. Simply copy this file to the same directory as the DAMBRK exe program.
Linear Mode
