#1 (permalink)  
Old 06-18-1999, 05:06 AM
Chris E. Maeder
Member
  
Posts: n/a
RE: WSEL overtopping X-Section
Dear Joe Kissel :

DAMBRK extends the sides by looking at the slope established by the last two top-most top- width entries.

If you have any additional questions or need any further information, please contact me again.

Sincerely,

Chris E. Maeder, M.S.
Senior Technical Engineer
chris.maeder@bossintl.com
Reply With Quote
  #2 (permalink)  
Old 06-18-1999, 11:44 AM
Joe Kissel
Member
  
Posts: n/a
WSEL overtopping X-Section
When the Flood wave is higher than the cross sections in the model how does dambreak handle the calculations?

Does Dambreak extend the cross sections vertically?
Reply With Quote
  #3 (permalink)  
Old 06-18-1999, 03:57 PM
Chris E. Maeder
Member
  
Posts: n/a
Re: WSEL overtopping X-Section
Dear Joe Kissel :

Note that DAMBRK extrapolates the top-width when the water surface exceeds that of the top most top-width entry.

If you have any additional questions or need any further information, please contact me again.

Sincerely,

Chris E. Maeder, M.S.
Senior Technical Engineer
chris.maeder@bossintl.com
Reply With Quote
  #4 (permalink)  
Old 06-18-1999, 04:57 PM
Joe Kissel
Member
  
Posts: n/a
Re: WSEL overtopping X-Section
Chris, how does it extrapolate? Does Dambreak extend the ends vertically or does dambreak use the last two topwidths/elevations points and extrapolates a slope of a line to extend the cross sections higher?
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are Off
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


All times are GMT. The time now is 01:18 AM.