|
Line Error in (XP) SWMM
Hello All,
I have been trying to figure out why I keep getting an error when I am trying to solve a model I have built. When I select RUN it returns with the usual list of warnings and no errors. The problem is when the file is saving I receive the following message.
swmm error:
A conduit had a negative length. See output file for the name
All my conduits have lengths associated with them. When I go back and delete the conduit named specifically in the output report to see what happens, the error just moves on to the next conduit downstream. I don't know what will remedy this error. Any help would be most appreciated. Thanks.
Sincerely,
Joe Crooms
Project Engineer
|
Linear Mode
