|
CUHP/SWMM5 Project- Error in Routing the Water
I am working on the hydrology for a basin south of Denver and used CUHP to generate unit hydrographs for each of my subbasins. I am trying to use SWMM to route the runoff. I set up the model and attached the .dat file containing my unit hydrographs. I ensured that all of the nodes were named the same as the individual basin hydrographs.
When I ran the model the run goes through sucessful, but I have a Contanuity Error of 0.00% for Routing. When I looked at the status report there was no water entering the nodes, and thus the system (a page full of zeros). It simply appears that there is a problem with linking the data up once it is brought into the SWMM model.... or that I am not allowing for routing the water? I have checked all .dat files and confirmed that they were all accurate, so I am positive that the problem llies in the SWMM model. Can anyone shed some light on this problem? Greatly appreciated.
|
Linear Mode
