Error Message

[murphytm]

WARNING! Extrapolated above the top of the property table at XSEC(S

While computing unsteady flow data I get the following error messages in View Computations Log file.

Does any one have any insight as to how to resolve this.

I have tried additional cross sections, changes my times steps...etc.

[MattZ]

The calculated water surface elevations are above the curves calculated by the HTAB program (geometry pre-processor). You will have to review your HTAB parameters for the cross sections where this error is occurring.

[murphytm]

Thank you for your reply.

I got all the errors ironed out, manipulated the raw data a little bit more, and finally got the model to run and give me a reasonible result.

The comment that unsteady flow modeling is difficult is an understatement.

Thanks to everyone for the help

Tina Murphy