Ineffective Flow Areas

I have identified some Ineffective Flow Areas in a model and run the project and had RMS draw Computed water surfaces on the cross sections. Why does it still show a water surface beyond the ineffective flow stations??

Avalisha Fisher, P.E.
Rowe Surveying and Engineering Company, Inc.
avalisha@rowesurveying.com <mailto:avalisha@rowesurveying.com>

Dear Avalisha :

Note that there is water in these areas. It is just that the water is simply "standing water" and not considered in the conveyance flow area.

If you have any additional questions or need any further information, please contact me again.

Sincerely,

Chris E. Maeder, M.S.
Senior Technical Engineer
chris.maeder@bossintl.com

Sorry to have bothered you. I figured that out after I Emailed You. I'd applied the wrong thing.

What I wanted to put in was a levee.