RMS Question

I tried to import the attached HEC-RAS project file(s) (created using Dotson's HEC-RAS software) into RMS but the file would not import. AutoCAD crashes after the import process begins (I get a message that RMS is "processing cross section ???" and then I get a message that RMS has encountered a "premature end of file"). Could you please look at the file(s) and provide any guidance as to why this is happening? I know that the file(s) will run properly using Dotson's HEC-RAS.

Thank you very much for your assistance.
Michael K. Nunley
W.K. Dickson

Dear Mike Nunley :

Actually the problem which caused the crash was an old bug and has been fixed. Can you download the latest build from our WWW site? The latest build should import the files correctly.

If you have any additional questions or need any further information, please contact me immediately.

Sincerely,

Chris E. Maeder
Senior Technical Engineer
chris.maeder@bossintl.com