Recutting cross-sections

Hello. It appears that the problem was that those cross sections were recut
off of the proposed topography, as were others. On this particular bridge
with the piers, it wasn't corresponding the new ground geometry with the
piers. So, we went in and imported in the old cross sections that defined
the bridge, and hand edited the ground geometry to match the proposed
contours. Now it runs fine, with no errors. Can you not recut from the
topo for bridge cross sections? Thank you for your time.

Andrea

Dear Andrea Bendlin :

Yes, you can recut the cross-sections. Select Input | Ground Geometry | Recut Topo. This command will then recut current cross-section.

If you have any additional questions or need any further information, please contact me again.

Sincerely,

Chris E. Maeder, M.S.
Senior Technical Engineer
chris.maeder@bossintl.com